P2138 Engine Trouble Code
Meaning of P2138 engine trouble code is a kind of powertrain trouble code and when the check engine light comes P2138 code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.
P2138 Fault Symptoms :
|
If one of these reasons for P2138 code is occuring now you should check P2138 repair processes.
Now don't ask yourself; What should you do with P2138 code ? The solution is here : |
P2138 Possible Solution:
Gasoline engines use spark plugs to cause an explosion of fuel within the cylinder. In a properly timed engine, this explosion occurs at the proper moment to send the piston to the bottom of the cylinder and provide power to the drive shaft. If the plug wires are out of sequence, the explosion occurs at the wrong time. The improper timing of the explosion sometimes pushes the cylinder the wrong direction or interferes with the turning of the crank. As a result, the engine stutters or backfires, if it runs at all. |
P2138 Code Meaning :
P | 2 | 1 | 3 | 8 |
---|---|---|---|---|
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine | Fuel And Air Metering (Injector Circuit Malfunctions Only) | Fuel Rail/System Pressure - Too High | Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector) | Clutch Position Sensor Circuit Malfunction |
The oxygen (02) sensors on your car measure the oxygen in the exhaust to determine how rich or lean the ratio of fuel and air are in the cylinders. Optimizing this mixture means better fuel economy and fewer exhaust emissions.
P2138 OBD-II Diagnostic Powertrain (P) Trouble Code DescriptionP2138 OBD-II Trouble Code The Accelerator Pedal Position (APP) sensor is installed on the upper end of the accelerator pedal assembly. The sensor detects the accelerator position and sends a signal to the Engine Control Module P2138 code.Main reason For P2138 CodeThe reason of P2138 OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High. |
P2138 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.